Great American Equipment Company

 

CNC ENHANCEMENTS AUTOBAR 400 BARFEEDER
Model AB-400, S/N 592, New 2002

Stock Number P12339

 

Mosnic RD3-112A Coolant Filtration System for Makino A-51, Makino A-55 and others

Mosnic RD3-112A Coolant Filtration System for Makino A-51, Makino A-55 and others

 

 

 

ACTUAL PHOTOS

The Autobar 400 Loads Spindle Length Bars (up to 60 Inches Long) from a
Tray into a Lathe. It Measures the Bars as it Loads them, and Positions
the Bar in the Lathe so the Bar is Ready for an Initial Cut Off or
Facing to Square the Front of the Bar. Each Time the Chuck or Collet
Closes and Then Opens Again the Autobar 400 will Feed Out (with or
without a Turret Stop) Enough of the Bar to Make a Part. While Doing
This, the Autobar 400 Screen will List the Number of Parts and the
Length of the Bar that Remains. It can also Provide a Count of Total
Parts Made and a Pre-Programmed Total Parts Wanted.
When There is not Enough Material to Make Another Part, the Autobar
400 will Pick up a New Bar Off the Tray and Prepare to Load it the Next
Time the Chuck or Collet Opens. The Lathe will be Stopped While this
New Bar is Being Loaded, and Restarted (without the Operator's
Assistance) When the Bar is in Position. Loading the New Bar will Push
the Remnant from the Last Bar Out into the Chips. The Autobar 400 will
Continue this Cycle until it Runs out of the Material on the Tray,
Reaches Total Parts Programmed, or is Turned Off.
The Autobar 400 is Equipped with a Keypad with a Main Menu with
Four Options. The First Two Options are "Run Job": These are Used When
You are Ready to Enter the Data and Run a Particular Job. The Third is
"Setup": This Tells the Loader Where the Front of the Chuck or Collet
is. Every Time you Change the Spindle Nose, You Must Use This Set up
Procedure. The Fourth is "Jog": This Allows You to Jog the Head Up and
Down, and Jog the Carriage Back and Forth.


CATALOGUE SPECIFICATIONS:

Round Bar Diameter Capacity ...................... 1/4" to 4" Range
Maximum Feed Length For Bars...................... 60"
Height Floor to Feed Guide (Adjustable) .......... 28" - 55"
Barstock Shape.................................... Round or Hex
Material Tray Capacity w/ 1" Bars................. 42 Bars
Material Tray Capacity w/ 4" Bars................. 10 Bars
Approximate Machine Dimensions.................... 92" x 65"
Approximate Machine Height........................ 81"
Approximate Machine Weight........................ 1,500 lbs



CONDITION: Machine Appears to be in Excellent Condition!
 

Great American Equipment can help you find used machinery...

Send mail to Great American Equipment Company with question or comments about this website.
Privacy Policy  Copyright 1998-2016 Great American Equipment Co