Great American Equipment Company

Stock Number K13070

Okuma Cadet

Okuma Cadet

Okuma Cadet

Okuma Cadet

Okuma Cadet

Okuma Cadet

ACTUAL PHOTO
OKUMA "CADET" CNC TURNING CENTER
New 1994, Serial No B972, Model LNC8, Series "CADET"
 
EQUIPPED WITH:
OSP #5020L CNC Control 
#ASA A2-6 Spindle Nose
Collet Chuck - 2-Axis Design
Hydraulic Tailstock
12 Position #V12 Turret
Chip Conveyor
Tooling (Jaws, Collets, ETC)
 
CATALOGUE SPECIFICATIONS:
Bore Diameter........................... 2.2"
Swing Over Bed, Maximum................. 15.75"
Turning Diameter, Maximum............... 9.84"
Turning Length Maximum, Chuck Work...... 9"
Turning Length Maximum, Shaft Work...... 19.69"
X-Axis Cross Slides Travel, Below 
Centerline.............................. 5.12" & 1.77"
Z-Axis Carriage Travel.................. 20.47"
Tailstock Quill Travel.................. 4.72"
Tailstock Quill Diameter................ 3.54"
Tailstock Quill Taper................... #5 MT
Spindle Speeds, Range................... 75 to 4200 RPM
Cutting Feedrate, Range................. .01 to 40 IPM
X-Axis Thread Feed, Maximum............. 236 IPM
Z-Axis Thread Feed, Maximum............. 354 IPM
Rapid Traverse Rate, X & Z-Axis......... 472 IPM
Spindle Motor, Horsepower............... 10 HP
Floor Space Required, L x D............. 8'10" x 6'1"
Weight, Approximately................... 10000 LBS
 
Great American Equipment can help you find used machinery...

Send mail to Great American Equipment Company with question or comments about this website.
Privacy Policy  Copyright 1998-2016 Great American Equipment Co